M S J
JACKSHAFT with Hoist - 25 Cycles / Hour, >80 Cycles / Day
|
|
MSJ fills the gap between regular Jackshaft and Gearheads. This is an Ultra-high end, heavy duty, V-belt drive operator for industrial High and Vertical Lift Sectional Doors or Rolling Doors and Grilles. It can be wall mounted on either side of the door. It incorporates a chain Hoist for manual operation.
|
Standard Features
|
- Chain hoist with electrical cut out
- Continuous duty motors up to 1 HP
- 5L V-belt, chain and sprocket reduction
- #50 Chain on Final Drive
- Cast iron pillow block bearings on output shaft and clutch shaft
- Solenoid Brake
- Adjustable Friction Clutch
- Output shaft speed: 47 rpm
- Heavy Duty Reversing Contactor
- Full Overload Protection
- C2 Wiring, B2 or D1 can be very easily set
- Pre-wired for Open Override, Safety Reverse, Radio Control
- Wall mounted on either side of the door
- Clearance: side room required is 20"
Main Options: Nema 4/12, Nema 7/9, Spreader, Hoist on left, Delay on Reverse, Timer to Close, Double Limit, Electronic Control Board
|
Available Documentation
|
Specification Sheet
Shop Drawing
3-Part Architect Specifications
Installation & Instruction Manual
Exploded View
|
Electrical Drawings
|
![](go1.gif)
|
Please select the electrical wiring drawing
you wish to view from the menu.
|
Electronic Control Board Specification Sheet
Electronic Control Board Installation & Instruction Manual
If you do not have
the
Adobe Acrobat Reader
click here.
|
|