|
Opera-SH with NEMA 4/12 or NEMA 4X Modification
JACKSHAFT with Hoist - 25 Cycles / Hour, >80 Cycles / Day
|
|
Opera-SH, fills the gap between regular jackshafts and gear heads. This is an ultra high-end, heavy duty, V-belt drive operator for industrial High and Vertical Lift Sectional Doors or Rolling Doors and Grilles. It can be wall, hood, or shelf mounted. It incorporates a chain hoist for manual operation with floor level disconnect.
The NEMA 4/12 modification is to be used for car wash applications and areas where dust, water, oil leaks or any other type of condensation is present. The NEMA 4X modification provides protection against corrosive environments.
|
Standard Features
|
- NEMA 4/12 or NEMA 4X compliant components
- NEMA 4/12 or NEMA 4X control enclosure
- Continuous Duty TEFC (4/12) or TEFC/TENV (4X) Motor up to 1 HP
- Cast iron pillow block bearings on input and output shafts
- Solenoid brake
- Emergency chain hoist with electrical cut-out and floor level disconnect
- 5L V-belt, Chain and Sprocket Reduction
- #50 Chain and Sprocket on Final Drive
- Output shaft speed: 41 rpm
- Heavy Duty Reversing Contactor
- Full Overload Protection
- C2, B2 or D1 Wiring can be very easily set
- Pre-wired for Open Override, Safety Reverse, Radio Control
- Wall, Hood or Shelf Mounted
- Clearance: side room required is 18"
Main Options: Spreader, Hoist on left (3 Phase only for time being), Delay on reverse, Timer to close, Double limits, Electronic Control Board.
|
Available Documentation
|
Specification Sheet
Shop Drawing
3-Part Architect Specifications
Installation & Instruction Manual
Exploded View
|
Electronic Control Board Specification Sheet
Electronic Control Board Installation & Instruction Manual
|
If you do not have
the
Adobe Acrobat Reader
click here.
|
|
|